You can get your Blower motor resistor replacement for free if a problem occurs during the warranty period.

The blower motor resistor of the Chevy makes the car fan run efficiently controlling the temperature of the car. The blower motor resistor is usually located at the lower right corner of the HVA module while the resistor is located between the blower motor and the front.

The installation of the blower motor resistor Chevy is quiet easy as you simply need to install the blower motor resistor Chevy and then tighten the screws and then connect the electrical connections to the Blower. This is the way to install the blower motor resistor as you need to install the right sound insulator and connect the negative battery cable.

To remove the Blower resistor Chevy you simply need to disconnect the negative battery cables and also remove the right sound insulator. And you can remove the blower motor resistor Chevy by cutting the portion of the dash board mat get to the rear resistor screw. Plus after disconnecting the electrical connection you can also remove the blower resistor screws and this will help you to remove the blower motor resistor Chevy too.

The Blower motor resistor Chevy usually has a connecting voltage of about 12 to 14 volts. And as this is the open circuit voltage with the motor in the circuit and the resistor is basically a current limiter and voltage reducer to the motor.

There is also a very simple way of getting your blower motor resistor Chevy to be replaced as you can drop the glove box door for easy access and the resistor are just two bolts .There are basically two type of blower motor resistor Chevy as the main resistor is located under the dash board on the right side while the other is located left quarter trim panel and is called the Auxiliary blower motor resistor.

But always be careful if your blower motor has blown and if you constantly change the resistor it will blow out again and again as the blower motor is not working up. Buy a resistor if you need a replacement but if the resistor has gone bad within the warranty time you can always get it replaced for free.

Professional help is the best way you can efficiently re-run up your blower motor Chevy without wasting much time as the guys know their job and instead of running about in circles looking for the best method to start it of on your own you can get access to the online sites and get all the petty details. Whereas the professionals know how to start up and from where they can get a replaceable parts that are required.